This is hard to explan but I'll try. The engine should be at normal temperture. (1) Use an optical tachometer such as Snap on # MT139 or Cummins # 3377462 to read the engine rpm (2) Adjust to low idle speed at the low idle speed screw. The srew & locknut are located at the rear of the fuel injection pump. (Looking at the pump with someone you trust slowly pushing the gas pedal. The lever at the rear of the pump will rest on a set screw when the pedal is at idle position. This is the low idle set screw). Loosen the lock nut at the bottom of the screw and adjust to factory spec. From the factory manual with an automatic 750 to 800 RPM with the park brake lock, transmission in drive & air conditioning on. (Real partner TRUST is needed here). With manual trans. 780 RPM park brake set, in neutral & air condition on.
The Cummins engine in a Dodge truck does not have glow plugs.The Cummins engine in a Dodge truck does not have glow plugs.
The refrigerant is R134a.
if it is a cummins, the order is 1,5,3,6,2,4
Yes the block will fit if you have the 03 engine mounts, you will have to have some knowlege on wiring to make everything work on the electrical side of things
how to adjust a 95 dodge neon clutch? how to adjust a 95 dodge neon clutch?
Does a 1995 dodge caravan SE have an interference engine?" Does a 1995 dodge caravan SE have an interference engine?"
Lower left side of the block.
OBD 1
It is located on the lower left side of the engine block, Follow the fuel lines and you will find it located to the rear of the engine mount.
300 - 2500 lbs/ft, depending on which MODEL of Cummins engine you have.
you can't, it is not adjustable.
A 1995 2500 could have a 5.9L V8, a 8.0L V10, or the 5.9L Cummins diesel.