Want this question answered?
The clutch bleed valve on a 2.2 liter Chevy Ecotec engine is located on the slave cylinder. To find the slave cylinder remove the battery, as it is mounted underneath the battery tray.
Remove slave and master cylinder from vehicle. Have someone stand on ladder holding master cylinder. Have someone work slave cylinder back and forth to force air out of system.
How do you replace a slave cylinder on a 1995 dodge neon clutch
You do something.
Right above the slave cylinder there is a bleeder screw. Just unsrew it and have someone hold in the clutch to start the bleed.
Replace the slave cylinder.
bleed it the same way u bleed the brakes
The clutch can't be adjusted. It is an hydraulic clutch. The clutch pedal sends pressure from the master cylinder to the slave cylinder on the clutch. IF you are having trouble with it the thing to do is bleed the air out at the slave cylinder. Have an assistant pump the clutch and hold it to the floor. Then open the bleed valve on the slave cylinder to let the air out of the system. On the final bleed hold the clutch to the floor and close the bleed valve on the slave cylinder. The clutch master cylinder operates of the brake fluid reservoir. Make sure you keep this full of brake fluid as you bleed the clutch.
There is no bleed screw on the 3.4 clutch. You have to unbolt the slave cylinder from the trans and drop it down so that it and the line are lower than the master cylinder, then pump the piston in/out to force any trapped air up to the master cylinder.
The same way you bleed brakes, but use the little bleeder valve on the slave cylinder. The same way you bleed brakes, but use the little bleeder valve on the slave cylinder.
Whenever you are having a problem with the clutch disengaging the engine from the transmission it is advisable to bleed the clutch slave cylinder. If the clutch can't be operated by bleeding the slave cylinder then the clutch master cylinder is gone and should be replaced.
Fill your slave cylinder using a hypodermic syringe (won't take much) and install it. Before you tighten the connection to the slave cylinder, bleed the air out of the line by filling the reservoir and pumping the air out until it runs clear. After it runs clear, tighten the connection to the slave cylinder.