It is best to replace entire regulator as one unit. Remove door panel. Remove bottom nut of regulator, and remove two top nuts of regulator. Loosen two bolts on bracket holding window. Support window, and carefully remove regulator as one unit.
Right behind the motor in the front of the transmission.
window motor, any auto parts store will have them
very simple just 2 bolts phillip head screw driver sit right o top of the motor.
Pull off door panel. Roll window half way down. Un-bolt window. There should be four bolts on the door panel that hold the motor. Take the arm off the left on driver side or right on passenger. Then motor should just slide out of the hole.
the water pump is located or the right side of the motor . it should be right under the plas. piece.
Remove the plastic cover inside the trunk that surrounds the motor. There should be a connect at the bottom of the motor on the right side. Disconnect it there.
window motor
Your are LSI model right? No there is not. window doesn't roll down or up. You might have bad window motor or switches. Check your door jamb wire connection that runs to the window motor. Good luck
It can be done by lifting the engine up.
Right side under dashboard. Remove plastic cover then look for a Round plastic cover.
You have to drill out the rivets in that panel to take out the motor
Take off the door panel-unsrew all the screws. Lift up on the panel. It pops right off.. Unplug any electrical connections.. set aside. Peel back the vapor barrier. Remove the motor.