start with your key in the off position. Turn key to "on" - not start.
Like this: on - off - on - off - on.
Your check engine light will flash the codes for you. All codes are two digits - There will be a break between numbers.
example: 5 flashes (break) 5 flashes = code 55 (this happens to be the "end of codes" or "no codes" if you did not receive any before the 55).
Hope this helps.
There are literally hundreds of diagnostic codes that would cause the check engine light to come on. Many auto parts stores will check the codes for free and tell you what is needed to fix it.
Diagnostic codes are generated by your on-board computer. They tell you what problems the computer has identified with your engine. The codes are numbers. The code numbers are read by an instrument that plugs into a special jack under the dash. Auto parts stores often will check your diagnostic codes for free, or you can have your dealer do it.
With a scan tool.
http://www.knizefamily.net/minimopar/fault/index.html there
buy a book like Chilton, and it has all the diagnostic codes listed in it. buy a book like Chilton, and it has all the diagnostic codes listed in it.
You need to have a diagnostic meter to read the codes, then book to tell you what they mean.
55 Means End of Code... Its nothing to worry about. Just means there is no codes
Nothing. All of the diagnostic codes consist of 2 digits. 'Code 3' must be incomplete.
Check the fluid, check for codes.
With a scan tool,
With a scan tool
with a scan tool.