How do you program garage door opener in Lincoln town car 2004?
Not sure if it's the same as the 1996 Jeep, but here are it's
instructions.
It's pretty easy. To help clarify I'm going to number the
buttons 1, 2, and 3 where 1 is the button on the outside, close to
the door, and 3 is the button on the inside.
Setting a button:
1.) Hold down the desired button and the LED will start to flash
slowly (if it is solid this means that it has already been
programmed and you must do a reset to program or select a different
button).
2.) Continue to hold the desired button and then hold the garage
door opener close to the visor and hold down it's button. You know
the visor is programmed when it changes from a slow flash to a fast
one.
3.) Release the buttons and test it out.
*** For rolling code garage door openers follow additional steps
below***
After you have trained the jeep remote as stated above, you will
notice pressing the button you have programed does nothing if you
have a rolling code garage door opener.
4.) Press the learn button on your garage door opener (usually
only have 30 seconds) and run back to the car and hold the button
you programed for 2 seconds and then release. Now, repeat the
"press/hold/release" sequence a second time, and, depending on the
brand of the garage door opener (or other rolling code equipped
device), repeat this sequence a third time to complete the
programming.
Resetting the visor controls:
1.) Hold down buttons 1 and 3, for about 15 seconds, until the
red LED starts to flash. Remember that this will reset all 3
buttons.
Hope this helps.