0
What else can I help you with?
How do you install engine 2002 Saturn sl2 4-cylinder?
How do you install 2002 saturn sl2 4 cyl
How do you install a ingnition for a 1995 Saturn sl2?
Switch or cylinder?
Where is the clutch bleeder valve on a 1993 Saturn sl2?
It SHOULD be on the clutch slave cylinder. Follow the hydraulic line from the clutch master cylinder down to the slave cylinder. Depending on the vehicle, it could be behind the dust cover of the bell housing.
What is the labor and materials cost to replace a slave cylinder in a 1997 Saturn SL2?
Its best to buy the slave and master cylinder prebled from the dealer. Its $140 or so but it saves alot of hassle if you dont bleed it right. Labor...Each side twists in to there perspective locations and then 2 bolts hold on the slave cylinder to the tranny.
Does a 1994 Saturn SL2 have a timing belt or timing chain?
The 4 cylinder Saturn's all had timing chains.
Install torsion bar 1993 Saturn sl2?
Vehicle does not have torsion bars
Where can I get a service manuel for my Saturn SL2?
1993 Saturn sl2
How do you replace your clutch master cylinder in a 95 Saturn SL2?
To replace the clutch master cylinder in a 1995 Saturn SL2, first, disconnect the negative battery cable and remove the clutch fluid reservoir cap. Then, locate the master cylinder, disconnect the hydraulic lines, and unbolt it from the firewall. Install the new master cylinder by reversing the removal steps, ensuring to properly bleed the clutch system to eliminate any air. Finally, check fluid levels and reconnect the battery.
Do you have to take down the fuel tank to install the fuel pump on a Saturn sl2 2000?
Unfortunately, yes.
What are some reasons that a 93 Saturn SL2 would be extremely hard to shift if the clutch is new?
I'm going to take a shot and say that it could be the clutch slave cylinder is not working correctly, ie. leaking fluid.
How many quarts of oil for 1999 Saturn sl2?
Oil capacity for your 1999 Saturn DOHC 4-cylinder motor is 4 Quarts of oil
Where is the coolant temperature sensor on a 1996 Saturn SL2?
The sensor is threaded into the coolant passage in the back of the cylinder head.
