Drain the water from the cooling system. Remove the water hose from the water pump. Remove the water pump retaining bolts. Remove the water pump. Reverse the process to install the new water pump.
You can change the water pump on your 2000 Mercedes E3 20 by first removing the water pump belt. Next remove the water lines. Remove the bolts that hold the water pump in place. The water pump will pull outward and can be removed. Reverse the process to install the new water pump.
Drain the water from the cooling system. Remove the belt from the water pump. Remove the water hose from the water pump. Remove the water pump retaining bolts. Apply a brand-new gasket and reverse the process to install the new water pump.
In order to remove the water pump on a 2000 Mazda Millennia, you must first remove the timing belt and the pulley for the water pump. Remove the pump itself by detaching the four bolts that are securing it. Next, replace any gaskets, install the new pump, then the pulley, and then the timing belt.
Sawsall.
Get the correct water pump and clutch for your car. Loosen the alternator and remove the fan. Remove the bracelets, hoses and the retaining bolts. Remove the water pump and replace it with the new one.
loosen the idler pulley and then remove the belt. then you remove the fan shroud i believe its like 4 bolts, then you remove the fan. after that you can remove the water pump.
remove timing belt and cam gears and backing plate to access water pump
First drain the water out and disconnect the battery then remove the fan and fan shroud and serpineteen belt then disconect the lower radiator hose and remove the pulley off the water pump then remove the heater hose that's connected to a pipe off the water pump and then remove water pump.
Drain the water from the cooling system. Remove the water hose from the water pump. Remove the belt from the water pump. Remove the water pump retaining bolts.
Unless there is an access panel in the trunk, which is doubtful, you will have to remove the fuel tank from the vehicle to access the pump.
disconnect hoses from water pump then remove the fan clutch{rent removal tool from your local auto parts store} the fan and the fan shroud don't for get the coolant tank also next loosen the four bolts holding the water pump pulley once they are loose remove the belt next remove water pump pulley after that unplug your coolant temperature sensor then you have 9 bolts holding your pump on remove them they take a 10mm you also need to remove your metal coolant tube from your old water pump and install it on your new one now just reverse the process
You will need to drain the water from your cooling system. Remove the water pump belt. Remove the water pump retaining bolts. The water pump will come off.