Want this question answered?
Remove the retaining ring at the top of your 1993 Chevrolet K 2500 ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
remove headlight switch
never mind found out on 1993 models you have to take the whole column out and sterring wheel off to get at it thanks anyways
you have to replace the whole steering column
Replace ignition switch for 1993 buick century?
Begin by removing the retaining ring at the top of your 1993 Nissan Quest ignition switch. Slide the ignition barrel out. Remove the wiring harness from the end of the ignition barrel. Reverse the process to install your new ignition switch.
On the 1989 Aerostar it is under the dash near the passenger door.
hi i need to remove ignition from an audio 1993 how do i do it
youve got to remove the steering wheel, take the locking mecanism off, then the mecanism for the signal lights off....whitch should only have a few screws.....then where the ignition switch is.....you should see a screw that looks like it goes through the switch..remove that then give the ignition switch a tug or two and it should come out
you will need security type star screw drivers , remove three screws from bottom of column cover,remove three screws from ignition switch.Replace with new switch.
it's located inside the steering column. Remove 3 screws on the lower steering column cover. Its the white plastic on the oposite side of the ignition.
A 1993 Ford Aerostar , 3.0L V6 engine has the distributor on top of the engine at the rear * The 4.0L has the Electronic Distributorless Ignition System ( EDIS ) It has ( 1 coil pack ) that has ( 6 ) towers for the spark plug wires