lift it up and engage the brake. if you look under it, it is attached through tthat little niche in the bottom, just pull hard enough and it'll come off....
with the correct tools
The ignition lock cylinder on a 2006 Chevy Cobalt is removed by popping off the steering column cover and inserting a screwdriver into the release hole. The cylinder can then be pulled from its housing and replaced.
cobalt 2006 fuel pressure pump
Remove tail light housing. Remove lamp. Replace lamp. Replace tail light housing.
How to replace front middle grille in a 2006 cobalt ls
all the trim panels are held in by clips and they just simply snap off
place flat screwdriver behind and pry outwords repeat around hole crank.
I have to replace the drivers side door handle on a 2006 Buick Lucerne. How do I remove the panel to access the bolts on the handle. (Like most panels there isn't visible screws to remove the panel.
Open your trunk, remove the carpet as if you are getting to the spare tire and the batterie is located there, remove it with a socket wrench and take it to your local autozone for charging.
Take inner door panel off and the plastic deflector paper and there are 2 10 millimeter bolts that hold the handle on, tighten the bolts and your all set.
will rear door handle work on the front door 2006 ford fusion
you will have to replace the handle, the inside door panel has to come off and then you can get to the 10 millimeter bolts that hold the handle on unless it's a 2 door and then your glass will have to be taken out of the regulator and lifted out of the back track to be able to get to the bolts, unhook the plastic clip that holds the handle rod to the latch and take the bolts out and your handle will come out.