Want this question answered?
The flasher unit on a Mazda 323 is located on the end of the flasher lever. Remove the lower steering column to bring the unit to view.
it is not practical to change the head unit on a RX8 The above answer is correct. There are many ways to make an after market head unit "fit" into the RX8, but you will probably lose the steering wheel stereo controls. You can connect aftermarket amplifiers to the stock head units speaker output and use aftermarket speakers. Get the MP3/CDROM addition for the stock CDROM head unit from a Mazda dealer.
could someone please tell me how to remove the front headlight unit from a Mazda 6.? the light housing where the bulb goes is loose causing my light alighnment to be off and i cannot get my hand in from behind to try to fix it.
it pulls out.
You can remove the radio unit from your 1997 Nova with a flat head screwdriver and a Phillips head screwdriver. You will not need any other tools to complete the task.
To remove the headlight on the mx-3 you must unbolt the front bumper, loosen all 4? bolts and disconnect the headlight wiring. The whole unit should just pull right off.
To remove the headlight on the mx-3 you must unbolt the front bumper, loosen all 4? bolts and disconnect the headlight wiring. The whole unit should just pull right off.
yes, easily...you will need a new head unit though. if you want a sub you will need a head unit with RCA outputs to connect the ammplifier. i run a panasonic head unit, 1200w amp, 2 12" subs, 4 mids and 2 tweeters in my 89' familia
No the factory head unit on a 2001 Mazda Millenia does not have pre outs. You can easily make your own pre outs if you want to keep your factory head unit with a line output converter (LOC). The converter takes the wires from the back of the radio to the rear speakers and converts them into 2 RCA pre outs. Hope this helped.
The clutch slave cylinder on a 91 Mazda 626 DX is located on the clutch bell housing. To replace the unit, first remove the hydraulic line and turn the line cap counterclockwise. Remove the two bolts holding the slave cylinder in place. Reverse directions to install new unit.
It is different for every car and usually involves disassembling the dash to some extent
It's on bottom of the navigation DVD unit under the seat. Unfortunately you have to remove the whole unit to view it. Honda will charge about $60 to remove it.