0
How do i remove the high brake lamp cover on a Lexus LS 430 to replace the light bulb?
Wiki User
∙ 14y ago
Assuming the 430 High Brake lamp cover is identical to the LS 400, it is as follows:
The high brake lamp cover is attached by four clips; two in the back of the assembly and two in the front. The front ones need to be released by gently and carefully pulling the cover up; the back ones then act as a hinge to allow the rear of the cover to move up. Then by pulling the cover toward the front of the car, the entire assembly comes loose.
Be advised that the clips are plastic, and they are mounted into the cardboard like rear deck. Therefore, being gentle is important to preserve them. I used two small screwdrivers, inserting them under the left and right sides of the cover, and carefully moving them to gently pry the front of the cover up.
Once the cover is free, there are two bulb housings. Each require a 1/4 turn to open. The bulbs are 921 18W.
Once you have replaced the bulbs, use the front clips to guide the cover back snug with the rear window, and pop down the front.
It is also a good idea to test the bulb before you replace the cover. Just step on the brakes.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you remove cover to replace brake light on 05 kia Rio cinco?
How do you remove cover to replace brake light on 57 kia Rio
How do you replace brake light on Lexus RX300?
The brake light assembly can be access through the cargo compartment. Remove the cover to the brake light assembly. Take hold of the brake light connector, push in and turn at the same time. The brake light will come out. Reverse the process to install the new brake light.
How do you replace the third brake light in a F150 1995?
you remove plastic red/white cover with 2 screws and remove bulbs.
How do you replace a rear brake light on a Nissan primera?
To replace the rear brake lights on a Nissan Primera first open the trunk lid. Locate the tail lights and find the plastic cover which hide the bulbs. Remove the cover and then the bulb. Replace with a new bulb.
How you you change the high mount brake light on 2001 Lexus RX300?
Remove the wiring harness from the high mount brake light. Remove the back cover of the brake light assembly. Take hold of the brake light connector, push in and turn at the same time. Reverse the process to install the new brake light.
Replace brake light in a Lexus es300?
The 3rd brake light can be replaced by removing the subwoofer cover by pushing down and towards the front of the car, other brake lights can be replaced by opening velcro covers on inside of trunk lid.
How do you replace front wheel bearing Honda odyessy?
Jack up the Odyessy. Remove the wheel and the brake caliper. Take the brake rotor off. Remove the axle nut cover, and the cotter pin. Remove the axle housing. Replace the inner and outer bearings as well as the races.
How do yoo adjust the Parking brake on a Lexus is 300?
Remove the cover of the parking break handle. On the back (opposite the button you push to release) there is a little nut to tighten and loosen.
How do you remove brake light cover to change bulb on 2001 Ford Focus ZX3?
How do you remove the brake light cover on a ford focus
How do you remove the brake light cover on a 1991 tracker?
how do you remove the brake light cover on a 1991 gmc tracker? Do you go from the outside or inside?
How do you replace the rear window brake light on a 92 ford thunderbird?
Get in the back seat and grab the rear brake lite and pull the cover toward you. Bulbs are then remove able.
1999 Pontiac Montana brake light bulb replacement?
In order to change the brake light, check your manual for directions. You will need to remove the cover and replace the burnt out bulb.
