How do you replace a rear brake light on a Nissan primera?


Top Answer
User Avatar
Wiki User
2014-08-23 03:13:21
2014-08-23 03:13:21

To replace the rear brake lights on a Nissan Primera first open the trunk lid. Locate the tail lights and find the plastic cover which hide the bulbs. Remove the cover and then the bulb. Replace with a new bulb.

User Avatar

Related Questions

How to replace a brake light on a nissan Tiida hatch back.

How do i reset my service light on my 2004 Nissan

I need to remove the fuse for the ABS light on my 1998 Nissan Primera GX. Where is it ?

how can i replace a brakelight bulb on a 2002 nissan frontier?

Remove the light assy and screw it in from the rear.

You have stumped the wizzard as I find no such animal.

May be the switch became defective. The solution is to replace it.

I just had this problem on my 98 Frontier because the brake lights were staying on. I had to replace the brake light switch and the brake light button for it to go out.

how to change a brake light on 2002 Nissan altima

Take out the two screws and replace one or both of the lamps.

its controlled by the button on the side of your gearstick (auto).

It's integral within the transmission.

The 1998 Nissan center brake light is a sealed unit. The entire brake light unit will need to be replaced. Remove the wiring harness. Remove the brake light retaining screws. Reverse the process to install the new brake light unit.

why or how do i find the brake light switch on my 1997 nissan 200sx. how do i chane it out.

The brake light switch on a Nissan is located just behind the brake pedal. It sends a signal to the brake lights when the pedal is pressed to turn them on.

I changed my rediator and the engine light came on and remained on, how do i get this light off

You can find the 2007 Nissan brake light fuse in the fuse box. The brake light fuse will be in the second column, third from the top. here you can see every step to that question.. I just did it.. and works :) by Paulo Fernando!!

How do you replace dashboard light on 2000 Nissan almera

check and see when your brake pedal is not pushed down if it is pushing the brake swith pin back in if so you need to replace the brake light swithch located behind the pedal

check your brake light ...then replace the stop/horn fuse

To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.