0
I'm not being obvious, you replace it. Where is it at or what is it doing? You either expand it or squeeze it together depending on what it is doing and located. Any snap ring sits in a groove. If the groove is towards the inside of the ring, you can usually just slide it over whatever you are working on and it will drop into place. If the groove is outside the ring, you have to compress it to get it in, or start on corner of it in the groove and work it into place with a flat screwdriver. Don't know if this helps.
What else can I help you with?
Where is the fuse box for a 1997 Chevy Venture?
Right side of dash,open pass door, it's on side of the dash behind snap panel.
What is the spark plug torque for a 2000 Chevy cavalier?
132 ft lbs. becarefull not to snap the plugs
Why would a serpentine belt on a 2001 chevrolety tracker snap after only 2 h ours of use?
I've got a better question, why is this question in the Chevy venture forum ?
How do you remove the front inner door panel of a 1998 Chevy Venture?
just use a minus scre driver and slide thru the interior cover, it will snap off the body.
How does one replace a 2002 Chevy Venture CV joint pictures would be a plus.?
first take off the cv nut i think its 36mm then take out the ball joint nut 18mm.use a "fork" to loosen the balljoint,then peel back the boot clear as much grease as possible from the inside of the cv joint.inside there is a snap ring holding the cv to the shaft.you will need a snap ring plier.while holding the snap ring open hit the cv with a hammer outwards of the shaft.it should come out easy.
How do you replace window regulator or window clips on rear window of 2000 grand am?
It is easy to replace the window regulator or window clips on the rear window of a 2000 Grand Am. The clips simply snap right onto the rails inside that door that connect to the window.
How do you install a side view mirror on a 2000 Chevy Venture?
You have to pull off the door panel. There are screws behind the door handle and behind the reflector. The light unbolts with three bolts. Than you need to pull the wiring harness. Doe this in reverse order for assembly. If you snap the plastic pins on the door panel new ones can be purchased at any auto parts stor.
When did snap backs come out?
They came out in 2000
What are the release dates for Girlfriends - 2000 Snap Back - 8.7?
Girlfriends - 2000 Snap Back - 8.7 was released on: USA: 12 November 2007
How do you replace the front turn signal bulb located on a 1998 Chevy S-10?
The front turn signal assembly will pop out with a little help. It is held in place by clips that snap it into place.
Change battery in key fob for Chevy Venture?
To change the battery in a Chevy Venture key fob, first, locate the small notch or groove on the side of the fob. Use a flathead screwdriver or a coin to gently pry the fob open. Once opened, remove the old battery, usually a CR2032 or similar type, and insert the new battery with the positive side facing up. Finally, snap the fob back together and test the buttons to ensure it works.
What are the release dates for Girlfriends - 2000 Snap Back 8-7?
Girlfriends - 2000 Snap Back 8-7 was released on: USA: 12 November 2007
