line up the t mark on flywheel. Then line up stamp on timing gear on cam with indent on top of head.
Check out my bio page for help on setting your timing.
line up the timing marks on the flywheel and cam
what filler guage size do i use to adjust valves on a 2009 Honda 500 4 wheeler
SPARK PLUG GAP SHOULD BE SET AT .080
i have a 1985 Honda civic and the valves need adjusting with a filler gage but i do not no what to set them on
You're setting valve lash here. It shouldn't make any difference what mark it's on. You want the valve to close completely when the rocker comes up. With no more movement after that. Once you get one valve set, roll the engine over half way and set the other one. Set valve lash on both valves with piston at top dead center, the T mark lined up with the mark. Valves should be set at .02 for that model. You do not have to roll the engine through to set the valves. but it is a good idea to roll it through 360 degrees after setting is complete and recheck the settings
For the 2004 Honda Recon 250 the valve specifications are the following: Intake and exhaust valves are both set to 0.13 mm (0.005 in).
A CR 125 does not have a timing chain. It is a two stroke which operates with reed valves.
how do you set the valves & what are the adjustments for the valves on a 2007 suzuki eiger 400
The intake valves line up with the intake runners on the intake manifold. The exhaust valves line up with the exhaust runners on the exhaust manifold or headers. With #1 at tdc you can set 1,2,5,7 intake and 1,3,4,8 exhaust valves. Rotate the engine one revolution to #6 tdc and set the remaining valves.
after the main safety valves are open