Read the capacitor that you remove
Capacitors come in various sizes, your question is to non specific (capacitor for WHAT) for a detailed answer.
The run capacitor is used when the load is functional while the start capacitor is used to produce the initial torque to drive the load.
A capacitor start motor is a split phase motor that uses a capacitor in series with the start winding to cause a greater phase shift, resulting in greater starting torque. It uses a centrifugal switch to switch out the start winding and capacitor once the motor is up to speed. I assume this switch is what you're referring to as a "relay".
There are two ways to read this: you have a burned-out run capacitor on your motor and a good start capacitor in your parts box, and you have a burned-out start capacitor and a good run capacitor. If the run capacitor's bad and you want to put the higher-voltage start cap in its place, the answer is yes. This is called derating, and the only thing it does for you is increases the lifespan of the capacitor because you're not working it as hard as it can take. If the start capacitor's bad, don't do this--they used a 440-volt capacitor in there for a reason.
It sounds like the starting capacitor is about to give up.
Capacitors come in various sizes, your question is to non specific (capacitor for WHAT) for a detailed answer.
Yes.
C=QV it doesnt depend on size.
This question does not make sense. For what use, or what kind, even the size are all factors of a capacitor. Look up the definition of what a capacitor is and then ask a real question.
You can not by-pass the capacitor in an electric motor. Most are capacitor-start motors which require the capacitor to be operational in order to start. If the capacitor is not working then it will need to be replaced.
No
The run capacitor is used when the load is functional while the start capacitor is used to produce the initial torque to drive the load.
Easier to start up. Running remains the same unless it is equipped with a run capacitor too. A run capacitor uses a little less current during run and probably runs a little cooler too.
A capacitor start motor is a split phase motor that uses a capacitor in series with the start winding to cause a greater phase shift, resulting in greater starting torque. It uses a centrifugal switch to switch out the start winding and capacitor once the motor is up to speed. I assume this switch is what you're referring to as a "relay".
There are two ways to read this: you have a burned-out run capacitor on your motor and a good start capacitor in your parts box, and you have a burned-out start capacitor and a good run capacitor. If the run capacitor's bad and you want to put the higher-voltage start cap in its place, the answer is yes. This is called derating, and the only thing it does for you is increases the lifespan of the capacitor because you're not working it as hard as it can take. If the start capacitor's bad, don't do this--they used a 440-volt capacitor in there for a reason.
A start capacitor is wired in series with the motor's start winding via a centrifugal start switch. The switch disconnects the capacitor and start winding once the motor has reached a pre-determined minimum speed. The motor then continues to run on its main field winding. A different design uses a "start-and-run" capacitor which remains in circuit whilst the motor is running.
If you lower the start cap size it may take milliseconds longer to start so it will still use the approximate same amt of power. Size? search for "appliance repair parts" enter your model number and you may be able to locate the value of the start cap. go from there.