You fit a supercharger to the inlet manifold.
Asking such a question indicates you do not have the basic understanding of mechanical engineering to accomplish this.
Take it to a qualified mechanic for advice.
Any instructions given here would be far too long and technical for you to follow.
yes and no you cannot install a positive displacement supercharge but you can install centrifugal supercharger
probably because it's carburated and it takes longer to start an old carburated car.
ground the diagnostic connector under the dash , set the timing , then unplug connector
Generally, a Positive displacement supercharger( 6-71,B&M, Whipple) are installed in between the carb and the intake manifold and run normal carburetors. Centrifugal supercharger for carburated engines are of a blow-thru setup (between the engine)and use specially setup carburators. All are driven by a belt that runs off of a pulley on the crankshaft.
depends if its fuel injected or carburated. tbi under drivers side door, carb urated should be right by carb
yes but there is alot of modifications i would do it the intakes will not swap but i guss someone sells one
Supercharge Me was created in 2007.
The Best of Supercharge was created in 1976.
you get supercharge when your health bar is blinking red
Carburated
carburated
You supercharge too.