yes but there is alot of modifications i would do it the intakes will not swap but i guss someone sells one
probably because it's carburated and it takes longer to start an old carburated car.
Chevy used the same bodystyle for the Camaro, with some yearly modifications, from 1970-1981
Yes, with very few modifications.
Chevy used the same bodystyle for the Camaro, with some yearly modifications, from 1970-1981
ground the diagnostic connector under the dash , set the timing , then unplug connector
Not without modifications and fabrication.
yes with some modifications maybe none
You fit a supercharger to the inlet manifold. Asking such a question indicates you do not have the basic understanding of mechanical engineering to accomplish this. Take it to a qualified mechanic for advice. Any instructions given here would be far too long and technical for you to follow.
I would think so since they're the same engine, only with some minor modifications
wont be a straight bolt on but with some modifications, it can be possible
Yes If you get the Correct Motor Mounts , And possibly hood modifications
depends if its fuel injected or carburated. tbi under drivers side door, carb urated should be right by carb