Connect the jumper cables to the source car, then connect the red jumper cable to the terminal with the red cover next to the windshield washer fluid tank, and connect the black cable to the engine mount (or some other metal ground). Wait a little while for the battery to charge, then try to crank. If it does not work, check the connections, wait a little while longer, then try again.
Take the switch out of the door and you can jump it just like you jump start a car.
No. If the starter doesn't work it can't turn the engine.
Jump start the car then go to auto parts store they will check the battery for you and let you know what the problem is.Most likely the battery is shot.
If the car will start in neutral but not in park then you may have a bad transmission safety switch. That switch confirms that the car is in neutral or park before it allows the 'start' signal from the key switch to reach the solenoid.
I am having same issue with mine I was thinking it is passlock i was told to take to dealer and have body control module re flashed , but I was also told it could be fuel pump not allowing car to start
Check your starter. The insulating bushing could be worn or damaged causing a huge drain on battery when you try to start the engine. It could also be a short with one of your lights or seat
You hook the red and black jumper cables to the red and black jump start posts under the hood on the passenger side.
1993-1997 you hook the cables to the battery. 1998-2004 you hook the cable to the jump start posts under the hood, passenger side.
If you need to jump start the car then the battery may be fully charged but it is defective and needs replacing. A full charged battery will read 12.6 volts at the posts with the engine not running. 12 volts indicates the battery is only 25% charged.
Not sure what engine you have but it is highly unlikely the timing would jump being that it is driven by a chain. If it was to jump it probably wouldn't start and possibly backfire in the attempt to start.
You hook the cables to the jump start posts under the hood on the passenger side.
The cast of Jump Start - 2008 includes: Ian Campbell Dunn as Joey McNeill Carlo Fiorletta as Tony Stella Lori Kee as Gerry Stella Art Lesemann as The Judge Paige Lussier as Sharon McNeill Laura Thies as The Bride