0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Difference between hot cyclone and cold cyclone in cfbc?
Main difference between hot cyclone and cold cyclone is 1. In hot cyclone flue gas temperature is above 800'c., in cold cyclone is is 400 to 500'c. 2. For 3-pass boiler we are used hot cyclone. 3. In reheater system we use hot cyclone to improve the efficiency of boiler.
Why does the water become cold when filling the bath from your combination boiler?
Because you are using the Hot water faster than the boiler can produce it. Turn the tap/faucet off a bit. Get the proper sized boiler
What is boiler draught?
The flow of flue gases in chimney due to difference in pressure i.e cold atmospheric air outside and hot gases in chmney is called as boiler draught.
Where on the hot water boiler is the shutoff valve?
Usually on the top, on the incoming cold pipe.
How to find problem with forced hot water no heat?
If the boiler is up to temperature, then the problem is with the pump. If the boiler is cold you should call a pro, as there is no way to diagnose it from here with out more info.
Can you hook domestic hot water directly into your boiler?
No. Hot water directly from boiler is not potable.
How do storms start?
hot and cold combined.
new boiler and hot water heater senior 11756?
new boiler and hot water heater
Truck engine temp goes from hot to cold?
it should start at cold
Which cheaper to run a combi boiler or a hot water boiler in your home?
combi
What to do when you lose hot water pressure and only have cold water pressure?
This depends on whether the hot water comes from a combination boiler or from a hot water tank with a header tank feeding it. For a combination boiler the fault would probably be at the boiler, possibly from scale in the heat exchanger. For the system that uses the header tank and a hot water cylinder it could be that the float valve in the header tank is stuck an there for it is not refilling the tank or debris has entered the tank and is blocking the outlet.
Radiators are cold on second floor source of heat is a oil fired boiler?
The fuel does not matter, it would be more relevant to post if you are hot water or steam, that is where your problem lies. If steam try raising the boiler cutout pressure a little bit and if hot water look at the boiler pressure, does the pump work, is the coupling broken and do you have air in the system that needs to be bled?
