0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do pilots taxi upon landing?
Pilots use two pedals on the floor to taxi after landing, the yoke is not used for steering
What does a pilot use to land?
Before setting up for landing pilots follow checklists. The pilot puts the aircraft in a landing configuration. To accomplish this, the throttle is set and the flaps are set to keep the right rate of descent and glide slope all the way down to the runway. On landing configuration It is very normal for pilots to use power to gain or lose altitude and trade altitude for airspeed. Prior to landing the pilot makes one final check to make sure the aircraft is ready to land, specifically the landing gear down. This is all done while listening to air traffic control and following approach plates.
How did pilots land on the ground safely in wwII?
more or lass as they do now. However, they didnt have GPS. They did use a system of radio navigation where ground transmitters be named a morse code signal which the pilots tuned to. There was no ILS or glide scope. Pilots "went visual" on every landing using their eyes and judgement to line up, stabilize and come in at a reasonable speed and decent rate
What is the use of wind vane in airports?
It shows the direction of the wind. Necessary knowledge for light aircraft pilots.
Why do most small aircraft not have retractable landing gear?
because light aircraft use the basic hydraulic system for its operation so its not necassary to be there
When landing an aircraft without power flyers use what term to describe this procedure?
DEAD STICK
Course followed by aircraft preparing to land?
(for small quiet airports see the "traffic pattern"), With a visual landing, The pilot will approach the point about 3 miles from the end of the runway at a 45 degree angle and configure the aircraft for landng(this is called the approach), once the aircraft is inline with the runway it will turn 45 degrees to be pointing down the runway (the aircraft should have received landing clearence by then, It will then decend as it nears the runway, This is called the (Final approach)The traffic pattern is a standard path followed by all aircraft when taking off and landing. The use of a traffic pattern is to ensure the safety of all aircraft operating in the area and efficiency in aircraft recovery. With a set traffic pattern pilots will be able to expect when and where to see other aircraft.There is no set length for each leg of the standard traffic pattern; however the typical traffic pattern has a 3-5 nautical mile (nm) final approach. When landing on an aircraft carrier the traffic pattern tends to be smaller as it is not required to use long approaches when landing on a moving carrier. For our purposes, we will use a standard separation of 2.0, between recovering aircraft/pattern aircraft. Proper Radio Transmissions And Pattern Positions Are Explained Below.The standard traffic pattern uses LEFT 90 degree turns at 1,000ft Above Ground Level.
How do helicopter pilots use math?
Helicopter pilots use maths in the following ways:- 1 To note the altitude of the chopper. 2 To note the speed of the chopper. 3 To calculate the speed of the upcoming storm. 4 During Landing
What does the company Bendix King produce?
Bendix King is a company which manufactures products for pilots and aircraft carriers to use on their aircraft. An example of these products include the Wingman Application for the iPad.
What is undercarriage?
a wheeled structure beneath an aircraft, typically retracted when not in use, that receives the impact on landing and supports the aircraft on the ground.the supporting frame under the body of a vehicle.
Fighter aircraft can stop on the shortened runway?
Fighter aircraft can stop on a short runway. On aircraft carriers, cables are used to stop them. Some fighters landing on short land runways use braking parachutes.
Do you use flaps to land an airplane?
Yes, Flaps are both used to create lift (on takeoff) and to slow the aircraft (on Landing)
