First you need to buy a bypass tool from an auto parts store. The next thing you need to do is to plug it into the immobiliser, press go and then you are done.
The immobilizer on a VT Commodore must be bypassed before you can tow it. To bypass the immobilizer, remove the body control module.
Holden VX Commodore was created in 2000.
firstly you need to buy a bypass tool from supercheap auto. Then all you need to do is plug it in to the immobiliser, press go and you're done.
The Body Control Module contains the Immobiliser. Before towing a vehicle, the Immobiliser should be bypassed. This can be done by removing the Body Control Module. Worst case scenario, use a flat bed to haul instead of tow a vehicle.
http://forums.justcommodores.com.au/holden-commodore-how-tos/5541-removing-vt-vx-door-trim.html
i dont know much about the vx commodore, but in my Vz commodore i like to put them in my center console and my coke in the cup holder DANNY!!!!!!!!
== ==
toyt
Quite likely not! The bumpers on VY's and VX's are quite different to a VP.
NoNo
check your inhibibitor switch
leave the ignition turned on for 45mins or until the red security light on the dash has stoped flashing then start beware if the engine stalls or you turn the engine off you have to wait anutha 45mins