Changing the spark plug wires is very simple. The replacement wires are the Bosch 5812-07098319 set for the V6 orÊBosch 5812-07098498 for the 4-cylinder. One at a time, disconnect the wire from the distributor and the plug. Replace with the wire that is the same length. ProceedÊ
You could change the spark plugs, sprak plug wires, computer chip.
As needed CheckSpark can quickly determine the health of your plugs and wires . You can get it on e-bay $24.95
Sounds like the spark plug wires are bad. Replace them along with the spark plugs.
The temperature sensor goes right on top of where the water hose from the radiator plugs into the engine. it is right next to the spark plugs wires.
Start with a full tune up. Change Fuel filter, air filter, spark plugs, plug wires, if you have over 60k on the car time to change that timing belt (change belt and pullies also a good time to change water pump) and dont forget your serpentine belt.
Are you referring to spark plug wires
Change the spark plugs and wires... Change the spark plugs and wires...
Straight forward job but be careful on replacing the plugs as they are deep also remember which lead goes where
The spark plug wires on your 1994 Chevrolet Caprice are quite easy to change. The spark plug wires simply lift off on each end. Put the new spark plug wires on and push until you feel a click.
No. However, newer plug wires can be extremely difficult to remove without damaging them.
The 1999 model, 90 hp Mercury outboard requires an NGK BUHW-2 spark plug, standard plug wires are acceptable.
Disconnect the battery, remove the spark plugs wires and boots and remove the spark plugs. Put in the spark plugs, replace the spark plug wires and boots, and connect the battery.