The process is quite straight forward; with a small flathead screwdriver, butterknife, or small key, gently insert into the upper left side of the bezel until it pops. Then repeat on the right side until the bezel completely pops out. Then remove the clock/bezel, unclip the wiring harness from the clock and remove the clock from the bezel. It generally takes 2-3 minutes, just work slowly. Check out my bio page for the website that gives you a pictorial on how to do so.
Which Forester, and which time? Are you talking about a clock or engine timing? Is the clock stand-alone or on a radio? Is it the factory radio? --Ken
The process is quite straight forward; with a small flathead screwdriver, butterknife, or small key, gently insert into the upper left side of the bezel until it pops. Then repeat on the right side until the bezel completely pops out. Then remove the clock/bezel, unclip the wiring harness from the clock and remove the clock from the bezel. It generally takes 2-3 minutes, just work slowly. Check out my bio page for the website that gives you a pictorial on how to do so.
Remove the clock decorative cover. Remove the clock retaining ring. Remove the clock wiring harness. Reverse the process to install the new clock.
remove trim, remove clock, remove clock light harness, and remove and replace clock light bulbs
Here's a video that demonstrates how to change the clock light. http://www.youtube.com/watch?v=L11UQk7G23U
if you are talking about the speedo clock first remove the cowling around the ignition then locate the two screws just under the dash by the clock then remove the plastic surround then you should see the screws that holds the clock in place,remove those and then gently pull clock forward and remove the plugs ontop of the clock.
I don't think there's a fuse for it.Try this link, it fixed my clock problem.http://www.subaruforester.org/vbulletin/f77/oh-no-my-clock-doesnt-work-3350/
it is in large park near forester prep school
This is a known problem and the repair isn't too difficult: http://www.scoobymods.com/forums/showthread.php?t=6386
A wrench
Follow the link below. Its a step by step on how to do this.
I don't have the answer for that one but it should be in your owners manual.