0
What else can I help you with?
Is there any way to disable the automatic door locks on a 96 Olds cierra?
Remove the fuse.
Were is the crankshaft sensor on a 1996 olds LSS?
Does the LSS have a 3.8L engine? If so, the crank sensor is behind the crank pulley/harmonic damper.
How do you replace crankshaft position sensor on a 1988 olds 98?
To replace the crank sensor you have to remove the harmonic balance taking special attention not to damage the pulley or the cam shaft. Remove the two 10mm retaining screws
How do you route a serpentine belt on Olds Cierra 1992?
How do you route a serpentine belt on a 1992 Cierra Oldsmobile
How do you replace the crank position sensor on a 92 Olds Cierra 3.3L and can it be done with out pulling the harmonic balancer?
The harmonic balancer must be removed to change the sensor because the crank position triggering rings on the back of the balancer are entwined with the pick-up, Sorry
Where is the camshaft position sensor and the crankshaft sensor located on a 1996 olds bravada?
It is located on the distributor under the cap and rotor Crank sensor should be on the front bottom of engine by the crank pulley
Where is fuel filter located on 1988 olds cutlas cierra?
where is fuel filter located on 1988 olds cutlas ciera?
Where is the crank censor on a 1990 olds 3.8?
The crankshaft sensor should be locate on the lower right hand side of the engine, between the lower pulley and the A/C compressor
How do you remove the crankshaft pulley on a 91 Olds Cutlass Ciera?
It takes a pulle r available from the parts store for rental.
1996 Olds Cierra check engin light flashing and car shaking?
same problem.
Where is the starter on a 1991 Olds Cutlass Cierra?
Follow the pos battery cable and it is at the engine end.
How do you remove the door panel on the interior of a 92 Olds Cierra to repair a broken door lock?
take all screws out and pull out around the edges, should pop out, then lift up by the window
