answersLogoWhite

0

To replace the crank

sensor you have to remove the harmonic balance taking special attention not to damage the pulley or the cam shaft. Remove the two 10mm retaining screws

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you replace the crankshaft position sensor 1988 Jeep Comanche?

To replace the crankshaft position sensor on a 1988 Jeep Comanche, first, disconnect the negative battery terminal to ensure safety. Locate the sensor, which is typically found near the crankshaft, and remove the mounting bolts and electrical connector. Install the new sensor by securing it in place with the bolts and reconnecting the electrical connector. Finally, reconnect the battery and check the vehicle for proper operation.


How do you replace crankshaft position sensor Oldsmobile 1988 ninety-eight?

You have to dismantle the entire engine,,,NO YOU DO NOT ITS JUST YOU HAVE TO DRAIN THE OIL TAKE THE OIL PAN OFF AND GET THAT DANG SENSOR TAKEN OUT THEN REPLACE IT!!


Your 1988 Oldsmobile turns over but will not start what can it be?

POSSIBLE CRANKSHAFT POSITION SENSOR.


Where is the crankshaft position sensor on a 1988 Volvo 740?

in the distributor in the rear of the engine. sometimes known as a hall sensor


Where is the crankshaft sensor located on a 1988 Oldsmobile cutlass supreme?

where is the crankshaft sensor located on a 1988 cutlass supreme


Where is crankshaft sensor on 1988 Chevy truck?

That year did not use are even have a crankshaft sensor.


How do you pull off a 1988 Mercedes Benz 260e crankshaft posicion sensor?

To remove the crankshaft position sensor from a 1988 Mercedes-Benz 260E, first, disconnect the vehicle’s battery to ensure safety. Locate the sensor, typically found near the crankshaft at the bottom of the engine; it may require removing any obstructing components. Unplug the electrical connector and remove the mounting bolts holding the sensor in place. Finally, gently pull the sensor out of its housing, taking care not to damage surrounding parts.


How do you locate a crankshaft sensor on a 1988 Oldsmobile Delta 88?

To locate the crankshaft sensor on a 1988 Oldsmobile Delta 88, first, ensure the vehicle is safely elevated and the battery is disconnected. The crankshaft position sensor is typically found near the engine's crankshaft, often at the front or rear of the engine block or near the timing cover. You may need to remove some components, like the air intake or accessories, for better access. Consult a repair manual for specific diagrams and detailed steps for your model.


Does a 1988 Ford Mustang have a crank shaft position sensor?

I think you mean CAMSHAFT position sensor.


Where is the crankshaft sensor on a 1988 jeep Cherokee limited?

Top driver side of the bell housing.


Your 1988 Jeep Cherokee Chief won't roll the engine over with the key It's like no fire is coming from the ignition switch Also the switch feels very loose when you turn the key like something is no l?

The Crankshaft Position Sensor is your problem. Replace this and it'll fire right up.


How can you change a camshaft position sensor on your Chevy astro van 1988?

Camshaft position is taken from the distributor, there is no separate sensor.