To locate the crankshaft sensor on a 1988 Oldsmobile Delta 88, first, ensure the vehicle is safely elevated and the battery is disconnected. The crankshaft position sensor is typically found near the engine's crankshaft, often at the front or rear of the engine block or near the timing cover. You may need to remove some components, like the air intake or accessories, for better access. Consult a repair manual for specific diagrams and detailed steps for your model.
The Crankshaft sensor is located behind the Harmonic Balancer on the front-passenger side
you have a sensor problem.
At the end of your air cleaner tube is a square box with 4 screws and a plug in. This is your mapp sensor
To install the throttle position sensor (TPS) on your 1986 Oldsmobile Delta 88, first disconnect the negative battery terminal to ensure safety. Then, locate the TPS on the throttle body, remove the screws or bolts securing it, and detach the old sensor. Position the new TPS in place, secure it with screws, reconnect the electrical connector, and finally reconnect the battery terminal. Make sure to adjust the sensor if necessary, following the manufacturer's specifications for voltage or resistance.
See the Related Links for "Here" to the bottom for the answer.
How to change a timing chain in a 1998 Oldsmobile delta 88
You have to remove the Vibration Damper first, then you will have clear access to the Crank sensor. Make sure when you reinstall it, the wires don't get caught in the Damper assembly and you have clearance where the sensor mounts. Easy fix.
Fuse 17 in a 1993 delta 88 Oldsmobile controls the air conditioner
The camshaft position sensor is located behind the water pump pulley. If looking directly at the pulley, it is at about the 10 O'clock position. TechJK ---------------------
78000 miles
yes
The correct tire size for a convertible 1972 Oldsmobile Delta 88 Royale is 225/75 R15.