It Runs From 50_100
You aren't supposed to replace them. You aren't supposed to replace them.
My 97 RL was shaking badly too despite new tires & l just had both cv axles replaced and the shaking ended.
The 2000 Acura 3.2 TL has two CV half shafts as its front axles. Aftermarket CV half shafts priced at wholesale are around 45$ each. Labor to install one half shaft for this vehicle should be 1-1.5 hours maximum. Assuming a labor rate of approximately 100$ the estimated total for one CV with parts and labor would be 150-200$.
the only parts that you can replace on the axle shaft are the cv joints that go into transaxle Cheaper to buy new axles 75 to 100 each side
If you have less than 100,000 miles on it, and are the original owner, it is still covered by warranty.
Yes
NO YOU CAN NOT. THE AXEL SHAFT IS WHAT HOLDS THE FRONT WHEEL BEARINGS TOGETHER,WHEN YOU TIGHTEN THE BIG NUT IN THE CENTER OF THE WHEEL. ARE ON THE END OF THE AXELSHAFT.
Sounds like a bad CV joint. On most cars, it is often more economical to replace the complete axle shaft on that side that has a bad cv joint. Hope this helps. Good-luck!
Yes
Inspect the Cv boots on the axles for tears. If no tears are found then replace the wheel bearing.
Yes you have two drive axles that use 2 CV joints, both have an inner CV joint and an Outer CV joint