If you get a light and lay down under the truck where the tube goes into the transmission and follow the tube where it runs up the back of the engine and way up towards the middle of the tube where it's hard to see, you will see one nut on a bell housing stud just below the head. You will need to remove that nut off of the tube bracket and then pull the tube out of the transmission and then work and turn the tube until it comes out. Trickey to get out. The NUT size is 13mm. There is a o-ring on the end of the tube where it goes into the transmission. Replace it.
where can i buy a transmission dip stick for a 1995 chevy blazer
The transmission fluid on a Chevy Blazer can be checked by idling the engine and allowing it to reach operating temperature. The dip stick can then be removed and checked based on the markings provided.
I use dexron 11 The transmission dip stick should have that info written on it.
It's back by the firewall. At the rear part of the engine.
dumb question, you put the transmission fluid is the hole the dip stick is in, its like this on all cars that i know of
it is the yellow stick coming out of the transmission make sure the motor is hot b4 you check it and on level ground and running not like oil you get no reading from it if it is not running
Standing in the front of engine, it will be on the left rear side of the engine. Back by the fire wall.
very very difficult.
Examine the transmission dip stick, it will tell you what type of fluid it requires.
Can't find transmission dip stick for a 84 custom 2 Chevy
There is no transmission dipstick in a 2005 cvhevy cobalt
It has no stick.