0
Bring them through the wall or floor and put a shut off valve on them.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How to Rough in sink drains and supply lines?
With a roughing book of course as not all fixtures use the same roughing
Can you rough in two drain lines to drain a double bowled sink?
You can, but why bother, a pipe from each, meeting in the middle is far simpler.
How many pipes needed for a bathroom?
Supply lines- Hot and cold water for each sink, bathtub, Jacuzzi tub, and shower. Cold water for each toilet. Drain lines- one for each sink, bathtub, Jacuzzi tub, shower, and toilet.
How high should sink water pipes be at the wall?
For a standard 30"- 34" high sink water lines are typically stubbed out of the wall between 16"-30" depending on the sink itself and rough in dimensions(if applicable). That does not mean that they can not be at another height, it really has to do with the sink and application layout.
If your rough in plumbing is not aligned with the sink drain what should you use to make the connection?
Most P traps and waste elbows allow enough play to make them work. But if alignment is to far out and you don't want to go but in and make corrections they do make flexible tailpieces that should work. If it's your supply fittings they make a varity of different length supply lines.
What is the rough in height for a mop sink faucet?
height of a mop sink faucet
What components is a plumber most likely to install?
New Water heater. Faucet and sink drain line repair parts. The sinks, commodes, house and yard water supply lines. Sewer lines
What are the release dates for Ask This Old House - 2002 Connecting Water Supply and Drain Lines for Kitchen Island Sink Rescuing Improperly Planted Trees 9-1?
Ask This Old House - 2002 Connecting Water Supply and Drain Lines for Kitchen Island Sink Rescuing Improperly Planted Trees 9-1 was released on: USA: October 2010
Should you used pipe tape on kitchen sink water lines?
No. Regardless of what type of supply line you use between the house supply and the faucet it will be a compression fitting. Copper lines with a nut and ferrule or flexible ones are both compression and do not need tape or pipe dope.
Does kitchen sink need to be grounded?
It is already grounded through the faucet and water pipes. Even if the supply lines are PVC, it will still be grounded through the water.
What are plumbing Rough-in stops?
Roughed-in plumbing refers to plumbing (water and waste lines) installed for future fixtures, for example, a bathroom in a basement. Stops refer to shut-off valves on water supply lines, required to shut-off the water to repair the fixture that they service. So "Rough-in stops" are shut-off valves on supply lines that are roughed-in. If they were not roughed-in, you would need to break concrete floor (to install waste lines) if/when you decided to add a bathroom to your basement family room.
What are the rough in measurements on a bathroom sink plumbing?
Your trap arm should be coming out from the wall at a height from the floor of 16-18", the cleanout just below the tee on the plumbing stack. The water lines should be at around 10-12 inches above the floor
