buy two gallons of dexcool antifreeze.around 25.00 a gallon.some go for full strenght or a 50-50 mixture,half anti-freeze and half water.locate peckcock at bottom of radiator and drain old anti-freeze out.there maybe a bleeder vavle on manifold to open up so air can escape out.pour in anti-freeze and close valve. job is done but never ever do this when engine is hot.a cold engine will prevent you from getting burned by hot anti-freeze.
It's supposed to use the orange Dex-Cool antifreeze common to GM vehicles.
how do you change a heater core on a 2003 ss Monte Carlo
Yes
where is the crankshaft position sensor on a 2003 monte carlo
How do you take a rheostat out of a 2003 monte carlo
My brothers 2003 Monte Carlo had this problem, was a plugged catalytic converter.
Remove the water supply hose from the top of your 2003 Chevy Monte Carlo thermostat housing. Remove the thermostat housing retaining bolts. Lift the old thermostat out. Drop the new thermostat in and reverse the process.
my guess is that you have to bring down the gas tank, it should be right there.
If you just want to add a little you can use the overflow tank to do it or if the radiator isn't full just take the radiator cap off and pour it in.
Yes
The Chevrolet Monte Carlo LS coupe has a curb weight of 3,340 pounds. General Motors produced the Monte Carlo from 1970-1988 and again from 1995-2007.
Fuel pressure for a 2003 Chevy Monte Carlo should be between 50 and 55 PSI. This ensures that the injectors will function properly.