answersLogoWhite

0

The motor itself is not replaceable. You have to replace the whole mirror assembly.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

How do you replace a driver side power view mirror on a 96 Chevy Blazer?

carefully grab the mirror and give it a tug carefull not breaking it, once it is off you can access the motor


Why wont your passenger side electric mirror work?

If your car is on and your driver side mirror motor is working then it can be anything from a break in a wire to a stripped gear in the mechanism to the mirror motor going bad.


How do you replace driver side Mirror motor on 1999 bravada?

you can not pea brain


How do you change the oil pump on a 1996 Windstar with a 3.8 motor?

The oil pan must be removed to gain access to the pump.


Engine diagram ford 3.8L engine 2001 windstar?

diagram of motor windstar 3.8


How do you remove the driver's side door panel to replace window motor on a 2000 Ford Windstar?

Breaking this question into the 2 primary components: how to remove the door panel - and - how to replace the window motor. Both are well covered in the "Related Questions" below


How do you unbind gears in a power motor for a Windstar?

There are a few "power motors" on a Windstar. Guessing the question might be referring to the window motor, see 'Related Questions" below for specifics about those...


How do you access the electric motor to the driver seat in a 2001 Infiniti QX4?

most of the time you can tap on the front motor under the seat, lower front and it will work temporary you must pull seat out to replace motor


How do you replace the right side mirror on a 1995 buick lesabre?

not very clear on which part of mirror, glass only or motor or whole mirror, is the mirror a power mirror or manual?most are going to be similar to replace entire assy , you will have to take off the inside door panel to access the 2 bolts holding mirror onto door and rewire controls to arm rest.to replace glass mirror only, tilt mirror so you can grab the mirror and pull and tilt mirror till it pops off of . be careful to replace line up motor adjusters and center snap , push gently till all adjusters and center pops back into placeto replace mirror and motor see above to remove glass mirror, then unscrew 3 screws holding the motor in place , either take of door panel off or splice new motor wires, (easier than taking off door panel) replace screws and glass ,done


96 ford Windstar power window motor removal?

I need to know the best way to remove and install the new window motor for a 96 Ford Windstar drivers side. Ray


What are the Motor mount bolt sizes on a 96 windstar 3.8?

The motor mount bolt size for a 1996 Windstar 3.8 is cross-thread a 3/8" bolt. That is the only bolts that will fit.


How do you replace a driver-side mirror on a 1993 Mazda MPV?

In the corner of the window is a black plastic triangle. Take a flat head screw driver and pop it off. It has some plastic tabs that hold it on. Then you will see 3 screws. Unscrew them. Rock the mirror assembly with your hand and it should fall off. You will then notice a connector for the mirror motor. Disconnect it. Replace in reverse order.