you can not pea brain
The motor itself is not replaceable. You have to replace the whole mirror assembly.
carefully grab the mirror and give it a tug carefull not breaking it, once it is off you can access the motor
In the corner of the window is a black plastic triangle. Take a flat head screw driver and pop it off. It has some plastic tabs that hold it on. Then you will see 3 screws. Unscrew them. Rock the mirror assembly with your hand and it should fall off. You will then notice a connector for the mirror motor. Disconnect it. Replace in reverse order.
If your car is on and your driver side mirror motor is working then it can be anything from a break in a wire to a stripped gear in the mechanism to the mirror motor going bad.
not very clear on which part of mirror, glass only or motor or whole mirror, is the mirror a power mirror or manual?most are going to be similar to replace entire assy , you will have to take off the inside door panel to access the 2 bolts holding mirror onto door and rewire controls to arm rest.to replace glass mirror only, tilt mirror so you can grab the mirror and pull and tilt mirror till it pops off of . be careful to replace line up motor adjusters and center snap , push gently till all adjusters and center pops back into placeto replace mirror and motor see above to remove glass mirror, then unscrew 3 screws holding the motor in place , either take of door panel off or splice new motor wires, (easier than taking off door panel) replace screws and glass ,done
ive actually done this before! inside the car, in the mirror location is a triangle piece of plastic, it actually pops off and the mirrior has 2 nuts holding it on and a plug for the electric motor... that's it!
I haven't done this, but I think that plastic trim piece in the corner of the window pops out to expose the fasteners that hold the mirror housing. A body shop can tell you how to replace the mirror and/or motor.
tom
Replacing 2002 Dodge power window motor driver side
Basically, just unscrew the plate and connector from the inside of the door and install the new mirror. It's very simple. You won't have any parts flying around doing it.
Have your blower motor resistor or blower motor checked out
To replace the blower motor on your 93 Bravada: Passenger side of the engine compartment, near the back of the compartment, there is a drum shaped component, usually black plastic. The blower motor slides into the center of this "drum" from the front of the compartment side, and is held in place by 6 bolts/screws. There is a short hose that connects to the blower motor and 2 wires. Disconnect the hose and the two wires, remove the 6 retaining bolts, and slide the blower out towards the front of the vehicle. You may need to remove the Engine Coolant overflow tank to remove the blower motor.