0
by useing a Flathead screwdriver to push the middle of the Factory Clips down and pry the sides of the plastic clips out if they don't rise up, then take off the plastic cover in front under the hood or Frunk below the hood latch then you will see the radiator, however the coolant cap is is the rear Engine bay on the drivers side in a MKII Toyota MR2
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What year was the SW20 mr2?
Its the mk2 late 1989-1999 Kind regards www.mr2-Ben.co.uk Toyota mr2 mk2 New & Used Spares
The speedometer and rpm gauge is not working in my 1991 Toyota MR2. How can i fix it or find out what is going on with it?
Sounds like the speedo cable may have snapped www.mr2-ben.co.uk Toyota mr2 mk2 New & Used parts
Will mr2 mk1 wheels fit mr2 mk2?
Unlikely, the MK1 is four stud, a mk2 uses 5 stud
Which battery is a correct replace for a MR2 Mk2?
According to My local Toyota Dealer. For a Mk2 non turbo like mine it's 12V 65AH. Currently less than sixty quid from Toyota. Don't know if the turbo is the same.
Can you fit some Toyota MR2 2004 wheels onto your Toyota MR2 2000 car?
Yes, the mr2 mk3 wheels fit all years 2000 to 2007. They will not fit the mk2 model which has a 4 stud pattern rather than the mk3 5 stud pattern.
How do you gain access to front indicator bulb on mk2 mr2?
probably by removing the plastic cover under the front of the car and reaching in from there
How do you change front indicator bulb on mk2 mr2?
Use a flathead and wedge it out
What cars in England use a 5 114.3 bolt pattern?
An MR2 MK2 1990
Where is radio fuse located on 92 mk2 mr2?
when sitting in drivers seat, it is in the kick panel near your left foot behind where the front hood latch is and up slightly higher. its a small fuse box, one of 3 on the mr2 mk2
Why has your mr2 head gaskett blown again?
I got my Toyota MR2 1990 Mk2 model head gasket fixed in November last year. I never started using the car until the end of December. At the begining of February the head gaskett blew again. Since I was using it, it was using a lot of water but could see no leaks. What can I do about this. Thanks..
How do you change the ignition barrel in your toyoto mr2?
if its the Toyota mr2 mk2, then this is easy,1, place the key in the ignition and turn to acc,2, press the small button that is sunk into the top of the barrel behind the facia,3, withdraw the barrel,hope this helps, as for any other way without the key i couldn't tell you, i have just removed mine this way and replaced it
Changing rear light bulbs on a Toyota MR2 mk2?
Hi there, I had the same problem trying to replace a bulb but struggled. You need a screwdriver to place between the yellow inddicator & bonnet. The yellow indicator should just snap out of position, then you'll see the screws.
