answersLogoWhite

0

enable

(enter enable password)

configure terminal

interface s#/#/# (substitute the actual number where the pund signs are)

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What mode must be in to configure IP address on a Cisco router?

interface mode


Which mode enables you to view and change the configuration of a Cisco router?

Global Configuration Mode.


What is port security in cisco?

port security is a CLI command used to restrict access to a network from a cisco switch by allowing access only to the hosts whose MAC addresses are defined in the switch. except the allowed hosts remaining hosts will be blocked based on the violation mode chosen.


Passwords can be used to restrict access to all or parts of the Cisco IOS Select the modes and interfaces that can be protected with passwords Choose three?

VTY interfaceconsole interfaceprivileged EXEC mode


How setup accesslist in cisco?

To set up an access list in Cisco, you typically use the Command Line Interface (CLI). First, enter global configuration mode by typing configure terminal. Then, create an access list using the command access-list [number] [permit/deny] [source] [wildcard mask]. Finally, apply the access list to an interface with the command ip access-group [number] in|out, depending on whether you want to filter incoming or outgoing traffic.


What is the default VTP Mode of operation for all Cisco catalyst switches?

2


What is USB mode?

USB mode is a Universal Serial Bus mode.


Which command or commands will require authentication to access the privileged exec mode?

RTRA(config)# line vty 0 4 RTRA(config-line)# login RTRA(config-line)# password cisco


What are main Cisco IOS Command Modes?

1. User exec mode 2. Privileged exec mode 3. Global configuration mode 4. ROM monitor mode 5. Set up mode


What mode requires a wireless access point?

Infrastructure mode requires an access point. Ad-hoc does not use an access point.


Cisco router 2801 serial port is manually down how you can enable this port?

router> enablerouter# configure terminalrouter(config) interface serial (interface number)router(config-if) no shutdownrouter(config-if) endrouter#substitute (interface number) for the actual int number.. eg serial 0/1you can find the number of the interface by using show interfaces from privileged mode


Which key combination allows a user to abort setup mode in cisco router?

To abort setup mode on a Cisco router, the user can press Ctrl + C. This key combination interrupts the setup process and returns the user to the command-line interface (CLI). Alternatively, users can also type exit to exit setup mode.