0
What else can I help you with?
What is global router configuration?
I'll go to hellis Cisco in a Cisco router. What would the prompt look like for global configuration
What is the default administration key code to change the setting on the Cisco 1841 router?
When resetting a Cisco 1841 router, the default password recovery and administration key is "confreg 0x2142." This allows you to reset the router with a new configuration.
What are some recommended books about Cisco routers?
Some recommended books about Cisco routers are: Cisco Router Configuration, Cisco Routers For The Desperate, Cisco Routers for IP Router, Cisco CCNA Routing and Switching.
What is the default configuration register setting for a cisco router?
0x2102
What command enables a DHCP relay on a Cisco router?
hal-loosi
What is the consequence of issuing the erase startup-configcommand in privileged EXEC mode on a Cisco router?
The startup configuration will be erased and if the router is restarted will boot with no configuration.
Which command correctly starts routing process in cisco router?
To start the routing process on a Cisco router, you typically enter the command router [routing_protocol] in global configuration mode, where [routing_protocol] could be protocols like rip, ospf, or eigrp. For example, to start the OSPF routing process, you would use the command router ospf [process_id], where [process_id] is a unique identifier for the OSPF process. This command enables the routing protocol and allows for configuration of related settings.
What is the purpose of NV RAM on a Cisco router?
That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.
On a Cisco router what interface is used to make the initial configuration?
console port
Which memory component on a Cisco router contains the dynamic system configuration?
Ram
What will a network administrator use to modify a configuration on a cisco router?
A Control Panel.
What is the purpose of the startup configuration file on a Cisco router?
The startup configuration file on a Cisco router contains the configuration settings that are loaded into the router's memory when it boots up. It specifies parameters such as interface settings, routing protocols, access control lists, and other operational settings required for the router to function properly. This file is stored in the router's non-volatile memory (NVRAM), ensuring that the configuration persists even when the router is powered off. Essentially, it serves as the baseline configuration that the router uses to establish its operational state.
