Global configuration
Global Configuration Mode.
from the global configuration mode
line configuration mode user executive mode * global configuration mode privileged executive mode interface configuration mode * enable mode8 What command is used to change the default router name to Fontana? Router# name Fontana Router# hostname Fontana Router(config)# name Fontana * Router(config)# hostname Fontan
On user exec mode type enable. When inside the privilege mode type configure terminal. You will then be sitting into global config after this. Please see below example: Router>enable Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#
That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.
Line passwords are encrypted with type 7 encryption.
All services must provide an encrypted password to function.
State four typical router configuration file items?
The reset button in a router let you remove all the configuration you do and gives you the default configuration from factory.
The System Configuration Dialog of a router would be restored to the device after the reload.
The startup configuration file on a Cisco router contains the configuration settings that are loaded into the router's memory when it boots up. It specifies parameters such as interface settings, routing protocols, access control lists, and other operational settings required for the router to function properly. This file is stored in the router's non-volatile memory (NVRAM), ensuring that the configuration persists even when the router is powered off. Essentially, it serves as the baseline configuration that the router uses to establish its operational state.