The startup configuration file on a Cisco router contains the configuration settings that are loaded into the router's memory when it boots up. It specifies parameters such as interface settings, routing protocols, access control lists, and other operational settings required for the router to function properly. This file is stored in the router's non-volatile memory (NVRAM), ensuring that the configuration persists even when the router is powered off. Essentially, it serves as the baseline configuration that the router uses to establish its operational state.
That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.
The startup configuration will be erased and if the router is restarted will boot with no configuration.
When a Cisco router is booted up for the first time, or is reloaded, the router will look into its Non-Volatile RAM (NVRAM) for the startup configuration file. Setup Mode is usedto configure a Cisco router or switch after start up to create a startup configuration file.
I'll go to hellis Cisco in a Cisco router. What would the prompt look like for global configuration
Page 11 of Routing Protocols and Concepts by Cisco. 1. POST 2. Loads Bootstrap program 3. Locates Cisco IOS 4. Loads Cisco IOS 5. Locates the configuration file 6. Load the startup configuration file or enters setup mode
Some recommended books about Cisco routers are: Cisco Router Configuration, Cisco Routers For The Desperate, Cisco Routers for IP Router, Cisco CCNA Routing and Switching.
0x2102
Global Configuration Mode.
console port
Ram
A Control Panel.
In a Cisco router, the memory that stores packet buffers and routing tables is known as Dynamic Random Access Memory (DRAM). DRAM is used for storing the operational data of the router, including routing information and temporary packet data during processing. In contrast, the router's startup configuration is stored in Non-Volatile Random Access Memory (NVRAM).