Hydraulic fluid should be poured in the oil tank.
You can add hydraulic fluid to Porsche convertible top motor by popping open your engine hood and then pouring the hydraulic fluid into the appropriate compartment.
under the seat were do you add the hydraulic fluid
In a Ford 4610, you need to add the hydraulic fluid to the rear axle. The Ford 4610 is a 1989 tractor that retailed at close to $19,000.
You might need to add some hydraulic oil to the pump. The pump is located in the trunk upper right side.. Further info and how2s.. www.autmotiveforums.com/chrysler/ lebaron
in the back axle
You add an excess pump tube to drain extra fluid.
Depends on which machine, I drove many and do remember they all had an easily accessible hydraulic tank.
Should be next to the brake fluid cup. DJ FLIP Housepartykings.com
After releasing the pressure by turning the bolt on the side of the pump, use a 5mm hex wrench to undo the bolt on the top of the pump. It is the only bolt that is silver and does not have wires attached to it. The fluid goes into that hole, using a syringe and/or tubing.
Barber chairs are often raised and lowered using gas or hydraulic struts. These struts work by using strong springs or pressurized gas. Some of these devices can be recharged, or have replaceable seals, but others are disposable items that are replaced as a unit.
The Ford Jubilee has three areas for fluid. The transmission has a filler cap near the gear shift. The hydraulic fluid has a filler cap under the edge of the seat and the differential has a filler cap behind the seat. There is a small dipstick on the right hand side to determine hydraulic fluid level.
HYDRAULIC PUMP ASSEMBLY LeBaron Convertible Review the complete service procedure before starting this repair. The convertible top on this model will raise slowly or make abnormal noise if the hydraulic fluid level is low. Disconnect the negative battery cable. Remove the sling well and floor cover from behind the rear seat. Disconnect pump wire connector and ground connection. Disconnect hydraulic lines from the pump assembly. Remove the motor pump assembly from the vehicle. The rubber mounts are pressed and locked into the mounting bracket. Pull up motor assembly to remove. To install: Position the motor assembly in the vehicle. Connect the hydraulic lines to the pump assembly. Attach the pump wire connector and ground connection. Install the sling well and floor cover behind the rear seat. Connect the negative battery cable. Fill the pump reservoir with Dexron