With my 2 floor jacks of a different stripe, both are configured with a short fine-threaded hex head bolt that serves as both drain and fill orifice, located topside of the piston assembly. Be sure to release all compression prior to opening and throughout refill process. A squeeze bottle like the one's used for mustard at the ball game, are perfect for refilling through that tiny little 1/4" hole.
Good Luck!
Follow this link (or copy and paste into your browser's address bar): http://www.hyjacks.com/H7.HTM then scroll about halfway down to find the instructions you seek. The task is a bit easier with a very small funnel that fits into the fluid reservoir hole.
Hydraulic fluid should be poured in the oil tank.
You can add hydraulic fluid to Porsche convertible top motor by popping open your engine hood and then pouring the hydraulic fluid into the appropriate compartment.
under the seat were do you add the hydraulic fluid
In a Ford 4610, you need to add the hydraulic fluid to the rear axle. The Ford 4610 is a 1989 tractor that retailed at close to $19,000.
in the back axle
Depends on which machine, I drove many and do remember they all had an easily accessible hydraulic tank.
Should be next to the brake fluid cup. DJ FLIP Housepartykings.com
The Ford Jubilee has three areas for fluid. The transmission has a filler cap near the gear shift. The hydraulic fluid has a filler cap under the edge of the seat and the differential has a filler cap behind the seat. There is a small dipstick on the right hand side to determine hydraulic fluid level.
thru the dipstick and vent hole by your bucket levers
In the front part of the hood, there should be a metal flapper that you can lift up. There will be a cap below it, that is where you add hydraulic fluid.
Either Power steering fluid or in certain cases 10 weight engine oil