0
Follow instructions included with the scope. If you don't have them, find a gunsmith.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Who makes Bec scopes?
It's a low-end scope manufacturer from Germany. Quality varies drastically in the overall lineup. I don't know what involvement (if any) they have with Asia. Their scope line consists of "EuroLux" or "GoldLabel".
If you have a scope on a 308 rifle how would you adjust for the elevation example if your ballistic table shows to adjust for 13 moa at 400 yards. at one quter moa on the scope how do you adjust?
You would have to have 52 clicks of adjustment.
What do knobs on a scope of a gun adjust?
top adjust the elevation up and down, the side adjust the windage right or left. .
How do you adjust a red dot scope?
If you don't have a manual, contact the maker.
How do you adjust a Nikon rifle scope?
No one can answer your question unless this is known...... Have you shot it with scope on? what is MOA adjustment for the scope? what is the yardage? Let me know & Ill walk u in.....
How do you adjust weaver K4 scope?
I read about the clicks equal about 1/4 inch, but where are the adjustments?
When you buy a scope is it already zeroed in?
If you just put a new scope on your gun it will not be zeroed in. you can get your local gun shop to zero it in or you can just shoot at a target and adjust it accordingly.
How do you adjust a weaver C4 scope?
you pop the caps off of the top and the left sides to expose the dials
How do you adjust a western field scope?
Loosen and remove the caps from the knobs on the top and right of the scope. Using a flathead screwdriver, turn the dials under these caps. Each click will adjust your shot (in reference to crosshair position, of course) 1/4 inch in the direction noted on the knob
If your rifle shoots to the right which way do you adjust the sights to shoot true?
You will want to make your scope point to the right more.
How do you install a throttle position sensor on a 2000 Chevrolet Impala?
You will need a volt meter to adjust the sensor and a lab scope to determine if you have a glitch in the sensor.
How much eye relief does one need when mounting a 4-15 scope on a power master 760?
That will depend on the scope and your eyes- but is ABOUT 3.5 inches. (Distance between your eye and the rear lens of the scope) It is the distance where you see the full image in the scope. You adjust it by sliding the scope forwards or backwards in the rings before tightening them down so that it fits YOU when holding the rifle in firing position. Please note- failure to pull a heavy recoiling rifle in TIGHT to your shoulder will result in a cut over your eye from being whacked with the scope.
