How do you adjust a clutch on a 94 Jeep Wrangler?

They are hydraulic and are not adjustable.

there are no struts on a 94 jeep wrangler, there are leaf springs and shocks

No.

Clutch needs adjusting or the synchronizers are going bad. Clutch needs adjusting or the synchronizers are going bad.

Jeep Wrangler wheel lug patterns years 1987-2006 are 5X4.5

It does not have a BCM.

No it should not fit 94 is a YJ and the 02 is a TJ

You cant it is a hydraulic clutch

AFAIK, there are no passenger airbags on a '94 Wrangler. I have a '94 Wrangler, and I have neither a passenger nor a driver side airbag. Hope this helps

Jeep Wrangler wheel lug patterns years 1987-2006 are 5X4.5 Jeep Wrangler wheel lug patterns years 2007-2014 are 5X5

Could be 3.07, 3.55, or 3.73

Engine compartment fuse box

The fuel pump is in the tank.

Any Cherokee, YJ or TJ model wrangler will work

It was the clutch master cylinder. It finally went completely out. I checked the slave cylinder, it looked and operated ok, so I assumed it was the master cylinder, I replaced it, it works now.

Synchromesh is the best I have tried

It should not fit, the YJ which is the 94, and the TJ are different body styles.

What make/model/engine size is it?

I believe you can get Grand Cherokee seats with warmers to fit in the Wrangler, you will have to rig up the wiring yourself though.

Maybe a Spicer.

Underneath the vehicle, upper drivers side of the transmission.

If the 4.0L is from a 1993-1995, then yes.

I have a 94 Wrangler and my module is under the front of the air box. It has 2 lines of numbers on it as follows: 56004262 60043

either your clutch is not disengaging completely or your synchro's are going or have gone bad. If you have a 4 cylinder model I'll bet it's the synchros, those ax5 transmissions are famously weak and suffer from synchro problems.

on a 94' it attaches to the same spot as the dip-stick tube.

The front speakers in a 1994 Jeep Wrangler YJ measure 4 inches by 6 inches. These speakers are in the dash of the vehicle.

The Wrangler uses a fixed orifice system. There isn't a pcv valve. The tube coming from the center rear of the valve cover is the orifice.

Should be on intake tube and has 2 wires.

ON my 94 you have to drive out the pin that holds the hydaulic fluid line to the master cylnider. I did this with a punch and a hammer. Then remove the pin holding the cylinder to the top of the clutch pedal (in the floor board) . Then simply remove the 2 1/2 inch nuts holding it to the firewall. Took me about 30 min.

Rear camber is not adjustable on a Cherokee with a solid axle.

It sure sounds like your clutch is worn

On the 94, the clutch gable goes through the firewall at the top on the drivers side of the engine compartment. The adjustment is where the cable meets the firewall.

your slave cylinder might be leaking,its bolted on your transmission.on a rubber cover.if its not leaking ,u might need a new clutch.

I believe there is no relay in the 94 YJ.... the power is regulated throught the switch.

start by checking for a wiring problem or possibly a bad pump

My 97 2.5l has 2. 1 right below the header and another right after the cat. in a 94 though there is only one.

The 1994 Jeep Wrangler dash pad is secured with eight retaining clips. Pry outward on each retaining clip and the dash pad will come off.

............................................................................................................................................... Check behind the Dash, glove box. Should be able to see it looking from under Dash.

Yes, Fuse panel under the dash, drivers side fuse #14 I think

Because the bands are slipping which has the same effect as slipping a clutch.

no it will not fit sorry. you need a TJ hard top. any years between 97 and 2006 are TJs. good luck finding one!

it may bind when using the clutch, it will squeal when not using the clutch, and stop when you do. You may also feel or hear a constant grinding like noise, this is the bearings going bad.

remove the nuts at the bottom of the hinges, pen the door, unhook the limiter strap and lift the door up

Yes 17's will fit, just make sure the bolt patterns match up.

87-95 was the first generation wrangler, the YJ. The roll cage should be the same as no major changes to the body were made until the TJ (97-03).

Look at the other question about the 95 yj, it's explained there... lataaaaaaaaa

You may be referring to a connector, if so; it is a plug not a box.

remove access plate on floor around shifter, 4 bolts hold the shifter onto the trans.

The wiper motor is on the driver's side, behind the dash board. if you fold you front windshield down, that will expose your wiper motor.

If you want to adjust them due to lifter chatter, don't do it. They all have a tendancy to chatter with a few miles on them. My '94 Cherokee has 200,000 + miles on it and it sounds like a Diesel truck. but she runs great