0
How do you adjust a crank sensor on a 1996 sebring convertable there is no way to use a feeler gauge?
Chrysler4me
The dealer sells a cardboard spacer the glues to the tip of the crank sensor. You then install the sensor and push it tight to the flex plate.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you adjust the camshaft position sensor in a Chrysler Sebring?
The cam sensor is not adjustable.
Where is the crank shaft sensor in a 1997 sebring convertable?
crank shaft sensor is near the oil filter. I have the repair manual but I am unable to past the page in here.
Why would a 2000 Chrysler Sebring Convertable all of a sudden speedometer stop working and transmission will not shift out of low?
VSS (Vehicle Speed Sensor) failure.
What would cause a 1997 Sebring Convertable engine to stall?
check the crank shaft sensor MAP, CRANKSHAFT, CAMSHAFT SENSOR THE COMBINATION OF THOSE SENSORS WILL LET THE CAR RUN RIGHT AND NOT STALL ANY MORE
What causes the cooling fan in a 1996 Sebring convertable not to come on after the fuses have been replaced?
Possibilities are: temperature sensor, relay (if it uses one), motor, connector(s). If the fan doesn't turn on when the AC is running, it's probably not the temperature sensor.
Where is the maf sensor on a 2002 Chrysler Sebring convertible?
A 2002 Chrysler Sebring convertible does not have a maf sensor.
Where is crank sensor located on 97 sebring lxi?
where is the crank sensor located on my 1997 Chrysler sebring lxi
Where is the MAF Sensor located on a 2002 Chrysler sebring sedan lx?
A 2002 Chrysler Sebring sedan does not have a MAF sensor.
How do you change the mass air flow sensor on a 1999 Chrysler Sebring?
A 1999 Chrysler Sebring does not have a mass airflow sensor.
Where is the mass air flow sensor on a 1996 Chrysler sebring convertible?
A 1996 Chrysler Sebring does not have a mass airflow sensor.
Could anyone tell me why my motor is bogging down on my 1999 Chrysler sebring convertable 2.5 liter engine. i have replaced spark plugs and wires and the electric fuel pump.?
Check your cam shaft position sensor. I had a similer problem
Where is the door sensor on a 2000 Chrysler sebring?
On my 2000 sebring convertable they are on the door jamb near the part that the door latches on to where the back of the door comes to rest. They look kind of like a bicycle tire stem and are held in by a single screw. After removing the screw, you detach by pressing a little raised tab that release the switch from the wire.
