The handbrake cables are adjusted by a nut behind the handbrake lever.
Basically remove the centre console section of interior between the two front seats, its fairly easy to do this. Then jack up back of the car and place on axle stands so both wheels are off the floor (remembering to take relevant safety precautions, like putting car into gear, and chocking front wheels for example).
Once this interior trim is removed, pump the brake pedal a few times, then pull handbrake lever up and back down 10 times.
Now pull up handbrake lever to the first 'click' on ratchet, take a deep socket on a ratchet (cant remember size sorry, possibly 13mm but not sure) and tighten the nut on the thread, then go and check if the wheel can or can't spin. Don't over tighten and release nut again a bit if need be, you want to be able to just turn the wheel by hand when on first click.
change hand brake cable citreon relay
change hand brake cable citreon relay
how do we adjust hand brakes
if its a right hand drive its located behind the little dash pocket to the right of the steering wheel it just pulls of
you be a weirdo
there is a small long bolt on the left side of the brake handle tighten the nut to adjust
handbrake adjustment on cougar
put your car in reverse and pull the hand brake. done
buy a Commodore!
at the rear brakes. remove wheels, & brake drums, adjust rear brakes to specs, and the E-brake will automatically be adjusted.
to adjust the hand brake you first have to loosen the hand brake witch at the hand brake its self. simpley pull back the cover thatr sourounds the hand brake. u will then see a 6mm threaded rod poping out. the nut that is on the end has 2b screwd off. you will need a 10mm socket for this. adjust totaly off then ur brakes will be free. once u have done your rear brakes then u can adjust the hand brake up by tightening the nut until u hav about 3 to 4 clicks.
do you mean cavalier hand brake?