Hi it's simple just park the car up and pump the brake pedal afew times,then with the hand brake off remove the centre console and you will find the adjustment there keep adjusting until you are happy with your adjustment,be carefully as not to adjust to much or you will have brake binding issues as it is a disc brake set up on the rear and the brake pads tend to expand when hot and contract when cooled down,so just adjust enough so you are happy with it and that it is holding/locking the rear wheels and refit centre console...."job done : )
the handbrake cable splits into two under neath the car. To adjust the handbrakes, alter the adjusting bold ratio at the bottom and on both sides of the car.... You can also remove the cover off the handbrake cable and tighten to size 10 bold that links the cable to the mechanisim inside the car
how do i adjust the handbrake of a hyudai elantra 1998 model
check the rear brakes for wear. if ok then just ajust them up to proper specks
Which year?
Read the instructions that came with it or contact the manufactuar and they could send you replacement instructions or tell you how.
Remove the plug on the back of the rear caliper and adjust the manual adjust screw (either a 4mm or 5mm allen). Make sure that it isn't adjusted too tight.
with a spanner.
Try looking under the middle console in your car, you should be able to adjust your handbrake from there
fit an anchor
i dont no
Cable underneath has a nut(s) to adjust.
Put the handbrake on and lift the rubber flap up just below the lever. Beneath that will be a 10mm nut, tighten that to adjust handbrake. 1993 micra should be about 5-7 clicks