Want this question answered?
In the center arm rest is a cover at the bottom that can be removed to expose the emergency brake cable, and a nut to adjust the tension.
I have a 2000 pontiac grand am gt 3.4 auto trans with rear disc brakes how do i adjust the emergy brakes no adjustment under car how is is done?
According to the manual there is no adjustment Many times the lining wears on the rear brake shoes and if you adjust the lining to the proper clearance with the drum it will also correct the emergency brake setting You may also need new lining There is a special adjusting device on the bottom of the brake shoes You have to remove the tire and brake drum to observe this
Remove the cover from around the brake handle by removing the two screw in the lower front and the two bolts inside the center console. Remove the top locking nut from the cable and then turn the other nut clockwise to adjust the brake.
There is no brake cable on your bike
Haynes repair manual, Dodge Neon 2000 thru 2003. Book #30036 Run it off a cliff
Is the brake fluid level LOW in the brake master cylinder in your engine compartment ? If the brake fluid level is LOW that will turn the brake light on in your dash
The 2000 Chevrolet Impala parking brake will have an adjustment bolt on the parking brake assembly. Turn the adjustment bolt to loosen or tighten the parking brake.
Try topping the brake fluid up
Sometime the brake shoes will rust or freeze to the drum. TAke it to a garage.
All of the brake pads on your 2000 Nissan will have adjustment nuts. You can turn the adjustment nuts to tighten or loosen the brake pads.
The light should be controlled by a switch operated by the emergency brake handle. The switch could be out of adjustment or could be bad.