answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you adjust for rough idling in a 1997 Acura RL?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What would cause a 1997 Ford Escort to run rough when idling?

The most common cause of rough idling would be a bad or clogged fuel injector. Also look for the hose on your EGR valve. They tend to come off in hot weather. If the hose comes off the engine will definitely run rough. I had to put a small hose clamp on mine to keep it from comming off. Spiritchsr1


Can the pcv on a 1997 Nissan pickup cause it to idle rough and cut off?

A PCV or connecting hose problem can cause great issues with a 1997 Nissan pickup idling. In fact, this can keep it from running, even if it does start, and the engine turns over.


Acura 1997 1.6 gaz tank?

how much gas per mile on a 1.6 1997 acura


How do you replace the head gasket on a 1997 acura 3.2 tl?

how to change head gasket on 1997 acura


Radio codes for 1997 acura 3.5 rl?

how do i unlock radio 1997 acura rl 3.5


When was Acura CL created?

Acura CL was created in 1997.


When was Acura EL created?

Acura EL was created in 1997.


Ticking noise when idling or driving. It's a 1997 Tahoe.?

It's a 1997 Tahoe


You just replaced the headlight assy on your 1997 Acura CL How do you adjust the beam There is a little screw by the gears do you turn that?

The screw is used to adjust the headlight beam. Pull towards a wall, and you can see the beam projection to set the headlights evenly.


Can you use 1997 Acura 2.5TL fender liner to install in a 1997 Acura 3.2TL?

Yes you can. They are the same part.


1997 Dodge Intrepid is idling rough have changed plugs. but still idels rough?

Spark plug wires? Coil pack? Dirty injector? Spark plug wires? Coil pack? Dirty injector? Spark plug wires? Coil pack? Dirty injector?


How do you adjust headlights on 1997 Acura CL 3.0?

pull up to a wall open the hood there should be adjustment screws near light assembly or on turn and watch the light on wall