Set idle speed to proper r.p.m, by adjusting the IDLE SPEED SCREW. Turn the IDLE MIXTURE SCREW or the AIR SCREW to for correct procedure, achieve highest speed and best response. The IDLE MIXTURE SCREW (FCR) controls fuel delivery to the idle port and the SCREW is located on the engine side of the carburetor slide. Turning the IDLE MIXTURE SCREW out will make idle and off-idle richer. Turning IDLE MIXTURE SCREW (CR, PWK, PJ, PE) controls the amount of air to the IDLE and SLOW CIRCUIT. This SCREW is located on the air cleaner side of the throttle slide and turning the SCREW out will lean the mixture and turning the SCREW in (clockwise) will richen the mixture.
The Honda XR80 was produced from 1979 to 2003.
How much Is a 1980 Honda xr80
Idle on a 1985 Honda Civic is adjusted through a idle air control valve. This valve is located near the intake. Adjust the valve by either loosen or tightening it.
To adjust the idle on a 2005 Honda Civic locate the idle control valve. The IACV and is found near the intake manifold. Open the top of the valve and tighten it to lower the idle or loosen it to raise it.
My opinion and my knowledge the xr100 is slower than the xr80 because I had both of those bikes and the xr80 always beat the xr100
If you are not able to adjust it down with the idle adjust knob you may have an airleak at the carb.
Honda Accord 1998-2002 model GEN 6 idle speed is control by internal computer. You need to bring it to the dealer to adjust this.
Yes, it does.
The price of a new Honda XR80 can vary depending on the year, condition, location, and any additional features or modifications. However, you can expect to pay around $1,500 to $3,000 for a new Honda XR80.
twist the screw under the carb
Go to the mechanic down the blocc
It should be on the carb!