answersLogoWhite

0


Best Answer

Release the handbrake then jack up the car making sure that the wheels are chocked so the car can not move and car is well suported.Take the cover off the bottom of the car around where the handbrake lever is. There is a cable coming from both rear brakes and where they meet there is a theaded bracket with a pivot release thenuts at the back and front of the pivotThen move the nuts front one first towards the front of the car and it should start putting tesion on the two brake cables adjust until you have a satisfactory amount brake. Remember to lock the nuts up to each other so they can't come loose. BE SAFE. mr2s do have quite a lot of travel on the hand brake lever so don't go to tight and end up with the brakes dragging.Good luck

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you adjust parking brake on a 1992 Toyota MR2?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you adjust the parking brake on a 1992 Nissan sentra?

Tighten it up!!


How do you adjust a parking brake on a 1992 Nissan Pathfiner?

on my 91 when i put new shoes on i adjusted the shoes out with adjuster until shoes touched drums and that also took care of my parking brake problem --- you may need rear brakes ???


How do you manually release the parking brake on a 1992 gmc sierra?

The 1992 GMC parking brake release lever can be found on the bottom of the dashboard. Pulling the lever towards the passenger compartment will release the parking brake.


Is there a manual parking brake release on a 1992 Cadillac Seville?

Yes, connected to the parking brake assembly is a little black lever, which when pulled will manually release the parking brake.


Why would the parking brake light be on even though the parking brake is not on for a 1992 Buick Centry?

I have a 1992 Chevrolet lumina and I had the same problem. what that means is your brake fluid is at a low level so check that.


Where is the diagnostic plug for a 1992 Toyota Previa?

Pop up the driver seat, and it's right next to the parking brake. It's square and sticks up.


Why won't the brake and parking lights turn off in a 1992 Toyota Corolla?

Brake and parking lights? Are you sure, the two aren't interconnected. Maybe it's just the brake light. If so, sounds like a bad brake light switch. If you step on the brakes and the brake and parking (sometimes called running lights) lights come on it sounds like you have a real problem. Suggest you have it checked right away.


What causes the brake warning light to come on and how do you fix it 1992 Celica?

Low brake fluid in master cylinder, fault in brake fluid level sensor, parking brake is on, parking brake sensor fault.


Why dont my brake lights work. I have a 1992 Toyota Cressida. Have checked the bulbs fuse and pulled the brake light switch and check with ohm meter and short light all ok. warning light stays on.?

Warning light usually indicates low brake fluid or parking brake not fully released


Why does Your 1992 Oldsmobile Achievas parking lights dose not work on mydashboard?

adjust you dimmer switch


Why does the brake warning light come on in a 1992 caprice?

Either the brake fluid level is LOW in the brake master cylinder located in your engine compartment , or the parking brake / emergency brake is on


What Is A Brake Load Sensing Valve On A Toyota Privia And Where Is It?

I Need Help With My 1992 Toyota Privia Please Answer My Question.