0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why does a gear shift on a 1998 ford expedition get stuck in drive?
If you are no longer able to shift, then it's possible the linkage is broken. If this is a periodic problem, you may need to adjust the linkage or shift cable so that everything is prooerly lined up
Shift cable for 1998 Ford Expedition?
The shift cable for a 1998 Ford Expedition allows the transmission to be shifted throughout the available gears. It is linked directly from the shift lever to the side of the transmission.
How do you adjust rear brakes on 1998 Plymouth Voyager Do you adjust them like the 1999 Dodge Caravan by driving backwards or do you adjust them manually?
Same as the Caravan...
If the shift indicator in a 1998 Plymouth Neon does not line up with marks P R N D etc after a mechanic replaced the shifter cable can this be the incorrect cable or is there an adjustment somewhere?
Take it back and have them adjust this. It is a very easy fix.
How do you replace a clutch cable on a 1998 Seat Inca diesel 1900 van?
Can adjust a self adjusting cable
How do you fix a broke shift cable on a 1998 Kia Sephia?
purchase a replacement cable and install it. its not reccomended to repair a broken cable
In a 1998 escort what would cause a automatic transmission not to shift into overdrive?
Linkage adjust
What is broken on 1998 Oldsmobile silhouette when gearshift will no move out of neutral?
Shift cable
How do you adjust the parking brake on a 1998 Chevy Corvette?
The 1998 Chevy Corvette parking brake can be adjusted with the parking brake adjustment bolt. You can also adjust the parking brake cable.
Where is the shift solenoid located on a 1998 Chevy Astro ven?
the kick down cable shifts the 700r4 trans
What does code p0755 mean on a 1998 Plymouth voyager?
I assume you have an electronic controled transmission. OBD II Code: P0755-----Shift Solenoid "B" Malfunction. Jim
How do you adjust a 1998 Nissan 200sx clutch?
I have replaced the the clutch cable on my '95 200sx 1.6L and it was easy. To adjust the cable go to the end of the cable where it conects to the level looking clutch arm in the engine compartment and look at where the clutch cable connects to the lever. Securing the cable on the backside of the lever there is a washer and screw that you can tighten or loosen to engage the clutch without pushing it all the way to the floor or you can adjust the other way to get the opposite affect. After I installed my clutch cable I had to go back about a week later and adjust the clutch (tighten the cable) because it appeared the cable had stretch a little from brand new to broken in condition. Hope this helps...
