Place the gearshift lever in the (D) position and hang a 1.4 kg (3 lb) weight on the shift control selector lever.
Move the gearshift lever to the first gear position, then move back two detents to the (D) position.
Hang the 1.4 kg (3 lb) weight on the gearshift lever.
Raise and support the vehicle.
Disconnect the transmission shift cable from the manual control lever.
Pull out the transmission shift cable adjustment lock on the shift cable body.
Place the manual control lever in the (D) position.
1 Rotate the manual control lever fully counterclockwise.
2 Rotate the manual control lever clockwise to the (D) position. (2 detents).
Connect the transmission shift cable to the manual control lever.
Push in the transmission shift cable adjustment lock on the shift cable body.
Note: If equipped with air suspension, reactivate the system by turning on the air suspension switch. Lower the vehicle.
Remove the 1.4 kg (3 lb) weight.
CAUTION: To prevent damage, do not adjust the transmission shift cable in any position other than (D). Verify that the vehicle will start only in P or N and that backup lamps illuminate in R. If not, repeat steps 1 through 7 and perform a digital transmission range sensor alignment.
You can not adjust the shift cable if you have having problems to where your exploer will not go into park then you will need to buy a new shift cable that is the only way to fix the problem
How do you adjust an F-250 shifter cable? 2000 model
I need to repair the gear shift cable in side a 2000 toyota corolla. How do you get in side the gear shift box to repair the cable end?
Type your answer here... how do you replace the shift cable on a 2000 expedition 5.4 liter
How do you adjust the kickdown cable on a Honda Civic 2000 ex
There is no brake cable on your bike
The shift cable has failed.
pull on it. The sheath takes up slack... makes the cable shorter.
Remove the air intake box and look beneath the master cylinder and you will see the shift cable. unbolt it from the transmission using the appropriate socket and undo the shift cable. on the inside, remove the center console and undo the cable inside as well
Depending on the model they are usually located on the transmission. Just below the shift linkage and cable. Follow the shift cable to the transmission and you will find it. you will have to remove the shift cable and lever , then unbolt the switch and work it up off the shaft.
check shift cable to transmission,it is either broke or stretched out !!!!
In the center arm rest is a cover at the bottom that can be removed to expose the emergency brake cable, and a nut to adjust the tension.